Miranda RCP-200 Manual de Instruções descarregar pdf (Página 26)

GUIDE TO INSTALLATION AND OPERATION

22 | RCP-200

This process sets up a filter that includes only devices that match the selected parameter. You may also set a filter that

does the opposite; that is, it excludes any device that matches the selected parameter.

To set up an excluding filter:

1. Navigate until a parameter of interest is shown on the screen

2. Press the SET FILTER button. It will start to flash.

3. Press and hold the ALT button, and touch the parameter of interest

4. The displayed list will now show only devices that do not match the selected parameter.

5. The header of the column in which the parameter was selected will display an F

6. The DEL FILTER soft key will be labeled and available

You may set up multiple filters by repeating either of these processes. The list will be filtered by the combined effect of

all the selected filter parameters.

DEL FILTER – the Delete Filter key is used to remove filters set up using the SET FILTER key.

Filters can be removed column by column, or all at once.

To remove an individual filter:

1. Push the DEL FILTER button. It will flash.

2. While the button is flashing, touch any column from which you want to remove all filters applied to the column

• All filters will be removed from that column.

To remove all filters from all columns at once:

1. Push and hold the DEL FILTER button for about one second, until it is extinguished.

• All filters will be removed from all columns.

5.2 Groups View

Groups are accumulations of controlled devices that share a common attribute; for example:

• Device Signal type (Video, Audio, Control, Reference, etc.)

• Device Model type (XVP-3901, DAP-1781, DEC-1003, etc.)

• Device Function (Audio processor, A/D, DAC, Video Proc Amp, Video Aspect Ratio Converters, Decoders,

Encoders, etc.)

• Physical Location (Densité frame, Rack, Room, Studio, Station, etc.)

• Devices assigned to an event or a program.

• Any other attribute that makes sense to the user.

About Groups - Groups are created and stored with the appserver(s) being accessed by the RCP-200. See the

appserver documentation for a description of the process. Groups appear as Folders in the iControl Navigator Logical

view, and show the included devices when opened.

• Note that groups will not be visible in the RCP-200 Groups view unless they contain:

A) At least one device if the ALL DEVICES soft key is activated

B) At least one supported device if ALL DEVICES soft key is deactivated

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 48 49

Sem comentários

Miranda RCP-200 Manual de Instruções Página 26