Miranda RCP-200 Manual de Instruções descarregar pdf (Página 22)

GUIDE TO INSTALLATION AND OPERATION

18 | RCP-200

4. Enter the IP address of the appserver where the iControl Access Control functionality is configured and touch

OK.

5. In the ACCESS CONTROL – XXX.XXX.XXX.XXX dialog, enter USER

and PASSWORD, select a domain from the pull-down list, and touch

OK.

6. The RESTART REQUIRED dialog will notify you that the RCP-200

must restart for changes to take effect. Touch OK and the RCP-200

will restart.

4.4.2 Logging IN to the RCP-200

Once Access Control has been activated, anyone wishing to use the RCP-200 must log in with a user name and

password. Access Control will remain enabled and USER/PASSWORD/DOMAIN entry will be required until an

administrator disables Access Control.

1. The ACCESS CONTROL – XXX.XXX.XXX.XXX dialog will appear

whenever the previous user has logged out, or the RCP-200 has been

restarted.

2. A user must enter USER and PASSWORD and select a domain in

this dialog and then touch OK before the RCP-200 can be used.

Note – in the current implementation, only the top-level domain will

appear in the drop-down list.

3. Once the USER/PASSWORD/DOMAIN information has

been entered, the header line on the CONFIG page will

show that Access Control is ON, and identify the logged-in

user by name and domain. The user’s password is not

shown, of course.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 48 49

Sem comentários

Miranda RCP-200 Manual de Instruções Página 22