Miranda RCP-100 Especificações descarregar pdf (Página 12)

GUIDE TO INSTALLATION AND OPERATION

DNR-101i/111i |

Figure 3.1 DNR-101i/111i iControl graphic interface window

The Config tab

The Config tab includes basic functions of the DNR-101i/111i; refer to image 3.1 to locate the different

elements.

The Noise Filter Mode is available only with the DNR-111i. Select MNR to access the Block Artefact

Remover in the Filter tab.

MENU:

MODE

→

MNR

The Bypass checkbox allows the video signal to pass through without any noise reduction.

The Split checkbox will output a splitscreen showing on the left side the improved image, and on the right

side the original, allowing the evaluation of the filtering effect.

Using these checkboxes is equivalent as selecting Bypass and Split using the pushbuttons on the front card

edge controls.

The User Presets are six configuration registers in an on-board non-volatile memory. Filter parameters are

saved to these registers, and may be recalled from them.

Select the User Preset to be used through the Select User pull-down box (the current selection is shown).

Then click Save User to store the current configuration in that register

MENU:

CONF

→

SAVE

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19

Sem comentários

Miranda RCP-100 Especificações Página 12